Mercedes Airbag seat sensor EMULATOR
VERSION WITH PINS
+ GRATIS
SEAT BELT SIMULATOR
Supported cars MERCEDES European version:
A W169 2004-2012
B W245 2004-2008
C W202 1997-2001
C W203 2000-2007
C W204 2007-2014
C W205 2015+
CL W215 1999-2006
CLC CL203 2008-2010
CLK W208 1997-2003
CLK W209 2005-2009
CLS W219, C219 2004-2010
E W210 1995-2003
E W211 2002-2009
E W212, S212, C207, A207 2013+
G W463 2002+
GL X164 2005+
ML W163 1998-2005
ML W164 2005+
ML W166 2011- 2015
R W251 2004+
S W220 1998-2005
S W221 2005-2013
SL W230 R230 2001-2012
SLK R170 1996-2004
SLK R171 2004-2011
SLK R172 2011+
VITO W638 1995-2003
VIANO W639 2002-2014
Thanks to this emulator you can check the correctness of the action of the airbag seat sensor. The emulator is used for diagnostic purposes.
Seat Occupancy Sensor Emulator is used to diagnose damage in the SRS system and allows you to confirm or exclude damage to the mat in the passenger seat.
The emulator connected in place of the original mat sends information to the airbag controller that:
* There is a working mat in the seat
* A passenger sitting on the seat
The emulator should be connected to the car's installation in place of the damaged mat. Find the seat mat connector under the passenger seat, remove the mat wires from the plug and check which ground, signal and power are. Then swap them with the emulator wires.
Cable marking:
Brown - GND (ground)
Green - signal
Red - 12V (power)
Before connecting the emulator use multimeter to check the correct power supply 12V, GND and signal.
The emulator is shipped as a universal one. If the error recurs or cannot be cleared, please configure a different program according to the INSTRUCTIONS.
When changing the program, disconnect the emulator and, after reconnecting it, clear the error with a diagnostic device.
Belt emulator is used to diagnosing damage in the SRS system and allows you to confirm or exclude damage to the seat belt buckle in the passenger seat.
Installation instructions:
- under the passenger seat, find the plug with two wires going to the seat belt buckle (yellow and blue)
- unlock the latch and pull the plug out of the connector
- insert the pins from the emulator into the plug socket
- insert the plug back into the connector
*The devices are not intended for permanent installation. In a car with a connected device, you must not transport a child in the front seat child seat, and always wear the seat belt on the passenger seat!
The product made and developed by ECU SERVICE
