BMW E60 E63 E64 E65 E70 E71 E81 E82 E85 E87 E88 E90 E91 E92 E93
+ GRATIS
SEAT BELT SIMULATOR
Supported cars BMW European version:
E60 FROM 2005-2010
E63 FROM 2005-2010
E64 FROM 2005-2010
E65 FROM 2005-2008
E81 FROM 2007-2011
E82 FROM 2007-2013
E85 FROM 2006-2009
E87 FROM 2004-2011
E88 FROM 2007-2014
E90 FROM 2005-2011
E91 FROM 2005-2011
E92 FROM 2007-2011
E93 FROM 2007-2013
Thanks to this emulator you can check the correctness of the action of the airbag seat sensor. The emulator is used for diagnostic purposes.
Seat Occupancy Sensor Emulator is used to diagnose damage in the SRS system and allows you to confirm or exclude damage to the mat in the passenger seat.
The emulator connected in place of the original mat sends information to the airbag controller that:
* There is a working mat in the seat
* A passenger sitting on the seat
The emulator should be connected to the car's installation in place of the damaged mat. Find the seat mat connector under the passenger seat, remove the mat wires from the plug and check which ground, signal and power are. Then swap them with the emulator wires.
Cable marking:
Brown - GND (ground)
Green - signal
Red - 12V (power)
Before connecting the emulator use multimeter to check the correct power supply 12V, GND and signal.
Belt emulator is used to diagnosing damage in the SRS system and allows you to confirm or exclude damage to the seat belt buckle in the passenger seat.
Installation instructions:
- under the passenger seat, find the plug with two wires going to the seat belt buckle (black and red)
- unlock the latch and pull the plug out of the connector
- insert the pins from the emulator into the plug socket
- insert the plug back into the connector
Do not place the child seat on the front passenger seat. Passenger airbag during a collision will open.
The product made and developed by ECU-SERVICE.
